NPVR Synology Docker with Octopus SAT/IP finds no channels

[sub]

That looks mostly there. It's managing to talk to the device, requesting it tune to specific frequencies etc, but doesn't appear to get any broadcast data the device.

Does your SAT>IP tuner have a web page that shows status information? like frequency tuned to, signal lock status, data rate to client?

[sylvio2000]

Thats all I have

[sub]

and the "tuner status" page?

[sylvio2000]

oh not all pictures are uploaded. I started a channel scan with npvr and made a screenshot from tuner status and stream status

[mvallevand]

Do you still have the linux system available? I'd like to see a verbose scan with it

Martin

[sub]

So you probably want to look at that page as NextPVR does it works through it's scan, and see if it cylcles between different quality/strength/lock status was the scan progresses. (I'm guessing it is, busy that would at least confirm if the tuner number we're looking at on that page, and that it does seem to be tuning)

(I've actually got this same device, but I haven't looked at it in quite a while, and couldn't remember exactly what the screens looked like)

[sylvio2000]

Here is the log from linux

[sub]

I think it's related to this:

Transport: RTP/AVP;unicast;client_port=52423-52424

I'm not 100% sure these ports are going to be the same each run, but if they are then you might also need port 52423 & 52424

[mvallevand]

The working run was

Transport: RTP/AVP;unicast;client_port=33380-33381

Martin

[sylvio2000]

I published all 4 ports, but nothing changed