Missing Audio

[FloFlow]

I am having the same problem. Looking at my log it seems that when you change channels that use different Audio Decoder then this error will happen because NextPVR cannot find it.

For instance, if I start the app and tune a channel that uses AC3 then it will work fine, but if I switch to one that uses MPEG-1 then I will see this error: "Missing audio? You don't have a MPEG-1 decoder selected. You can fix this on the Settings->Decoders screen.".

If I then close the app and the first channel I tune is MPEG-1 it works fine, but when I switch to an AC3 channel I will get the same error message but with the decoder it could not find: "Missing audio? You don't have a AC3 decoder selected. You can fix this on the Settings->Decoders screen.".

Seems to be a problem with NextPVR not being able to switch between decoders.

Please help!

I have exactly the same problem.
I think it's since I changed the motherboard or the CPU.
Any plan to work on this issue ?

[mvallevand]

Are you still using V4? if so, no work will be done on this.

Martin

[FloFlow]

Are you still using V4?  if so, no work will be done on this.

Martin

I'm on 6.1.3

[mvallevand]

You posted in a v4 thread. Post your zipped logs and we can have a look.

Martin

[FloFlow]

Ah ok my bad, I just a did a research and found the same issue.
Here you are. Thank you.

[mvallevand]

Did you enable EAC3 for LAV? I know it is required in France for digital That would need to be in both NextPVR.exe settings and in LAV properties.

2023-06-05 21:27:57.367 [DEBUG][1] audio renderer now EAC3

You are also not using the LAV video decoder which is often recommended.

Martin

[FloFlow]

Did you enable EAC3 for LAV?  I know it is required in France for digital  That would need to be in both NextPVR.exe settings and in LAV properties.

2023-06-05 21:27:57.367 [DEBUG][1] audio renderer now EAC3

You are also not using the LAV video decoder which is often recommended.

Martin

Yes everything enabled and working. As described above, it's like Next PVR can't switch of codec. If I restart it works for the current codec, but can't change.

[mvallevand]

I see now it is in multiple logs going from MPEG1 to EAC3 and vice versa the remapping doesn't seem to be working. Sub will need to look at this. EAC3 to EAC3 seems to be working.

Martin

[FloFlow]

I see now it is in multiple logs going from MPEG1 to EAC3 and vice versa the remapping doesn't seem to be working.  Sub will need to look at this.  EAC3 to EAC3 seems to be working.

Martin

Thank you

[sub]

Are you using LAV decoder for both MPEG1 and EAC3?