updated DVB-C tuning file for SAT>IP The Netherlands and question

[sub]

I initially wasn't able to see any LCN information in your ts file. After a bit of research I found a document saying ziggo use a proprietary method for LCN. This is not uncommon, but it's stored in a different location than other DVB services. I think I've got support for this working, but I've been unable to find a definitive list of channels on the internet to double check the numbers I'm now pulling out.

[mvallevand]

Was it table 5.2.9 here https://ziggo-main.aem.aws.ziggo.io/cont...nal_63.pdf

Martin

[sub]

Was it table 5.2.9 here https://ziggo-main.aem.aws.ziggo.io/cont...nal_63.pdf

Martin

Close. Same document, 4.8.2 SDT Descriptors.

[mvallevand]

It might even be 5.2.7 since when I looked at it with TSDuck I got this https://pastebin.com/kvvmzufz but was confused with the duplicates. Still from the first file of radio stations many were right like Tukker FM 0x10cc is channel 908 https://www.tukker.fm/vanaf-1-april-zijn...go-tukker/ but I couldn't map all ie GigantFM wasn't on channel 923 or Smeln FM on 915 like their web sites.

Still they probably are better than incrementing from 1.

Martin

[sub]

It might even be 5.2.7

This type of LCN was already supported (descriptor 0x83 on the NIT table), but I'm not seeing that data in the couple of example streams.

[mvallevand]

It might even be 5.2.7

This type of LCN was already supported (descriptor 0x83 on the NIT table), but I'm not seeing that data in the couple of example streams.

TS Duck reported them as EACEM/EICTA types and both had fullmux had them

Code:

    Transport Stream Id: 2098 (0x0832), Original Network Id: 1536 (0x0600)
    - Descriptor 0: Cable Delivery System (0x44, 68), 11 bytes
      Frequency: 386.0000 MHz
      Symbol rate: 6.9000 Msymbol/s
      Modulation: 256-QAM
      Outer FEC: not defined, Inner FEC: not defined
    - Descriptor 1: Service List (0x41, 65), 12 bytes
      Service id: 19401 (0x4BC9), Type: 0x19 (Advanced codec HD digital television service)
      Service id: 19402 (0x4BCA), Type: 0x19 (Advanced codec HD digital television service)
      Service id: 19405 (0x4BCD), Type: 0x19 (Advanced codec HD digital television service)
      Service id: 30401 (0x76C1), Type: 0x19 (Advanced codec HD digital television service)
    - Descriptor 2: Private Data Specifier (0x5F, 95), 4 bytes
      Specifier: 0x00000028 (EACEM/EICTA)
    - Descriptor 3: Logical Channel Number (0x83, 131), 12 bytes
      Service Id: 19401 (0x4BC9), Visible: 1, Channel number:  1
      Service Id: 19402 (0x4BCA), Visible: 1, Channel number:  2
      Service Id: 19405 (0x4BCD), Visible: 1, Channel number:  3

Martin

[sub]

I'll check it again, in case they're carrying them in a slightly different spot in the NIT. I know the existing 0x83 on NIT table stuff normally works, because that's how most people around here get their LCN numbers (including myself)

[sub]

NextPVR has only been scanning NIT Actual (table_id 0x40). They seem to only carry these LCN numbers on NIT Other (table_id 0x41). I'll add this.

[retrofan]

NextPVR has only been scanning NIT Actual (table_id 0x40). They seem to only carry these LCN numbers on NIT Other (table_id 0x41). I'll add this.

O cool, thanks for adding support for this.

Here's the channellist of Ziggo:
https://www.ziggo.nl/televisie/zenderoverzicht

Maybe you're seeing duplicates because Ziggo also uses Network ID 4444 for FTA and 5555 for all channels in my region?

[retrofan]

Channels in the 9xx range are local channels and are not listed on Ziggo their website. I will put that list with LCN later today in this forum so you can check :-)