NextTool merge error

[mvallevand]

I am assuming you just took the missing dll, so here is the 2.50 zip file I use.  I actually posted it here earlier https://forums.nextpvr.com/showthread.ph...#pid598908 and forgot about it.

I actually have a 2.60 version here don't know what  I changed.

Martin

[Jack_Burton505]

Should I replace the files I previously extracted with the ones in the zip you attached?

[mvallevand]

Why not, then we are comparing apples and apples.

Martin

[Jack_Burton505]

OK, ran it again and got a slew of errors. I'm going to switch to the browser in the linux computer and zip them. It'll take me a few minutes.

[Jack_Burton505]

OK, let's see if this comes through...

[mvallevand]

I told you your syntax was wrong and I see you didn't change that but it will need these three parameters

--merge oldnpvr.db3 /folder_to_import

Although you said you did, I don't think you created at least one of the symbolic links noted on the wiki which is why you got

Unable to load shared library 'e_sqlite3'

The wiki author didn't explicitly say to use sudo though, but that should be clear.

Martin

[Jack_Burton505]

I confirmed with a ls -l command that the softlinks are there for libe_sqlite3.so and libSkiaSharp.so, linked to runtimes/linux-x64/native, and I did do it with sudo.

[Jack_Burton505]

image of results of ls -l

[mvallevand]

Since when did a RPi run x64? Check the wiki.

Martin

[Jack_Burton505]

Okay, I just realized my mistake. I just got this Pi 5 and set it up; I was going to test on an old Dell laptop onto which I had put Ubuntu Mate, and set NextTool up there but never ran it. Then I guess I just duplicated what I did there when I set up the Pi. Let me fix that, and also the syntax of the command.

Glad I sent the image!