IR Blaster and DirecTV

[bobrap]

Is there a way to send a select/enter command to the DirecTV receiver after changing a channel with IR blaster? It changes the channel in GBPVR and sends the channnel number to the receiver but needs a select command to actually change the channel. Thanks.:confused:

[haripj]

I think the beta version of the IR blaster config software on the Hauppauge website has this option. When you run Blastcfg after installing the software, you should see this option. It only works for certain code-sets, however. In my case I use the set for D10 receiver, and it works on my D11 receiver.

[bobrap]

Said it doesn't work for my code set. Maybe I'll others and see if I can get one to work. Thanks. Anyone else got any ideas? TIA Found a key that works. Now if I could only get s-video in color and not b/w. Found my B/W problem was TWO bad s-video cables. Feel kinda dumb about that.:o