Terratec Cinergy 2400i DT beta drivers

[AlanC]

Terratec Cinergy 2400i DT beta BDA drivers version 1.0.3.260 do not work with GB-PVR.
While Terratec Home Cinema and ScanChannelsBDA_EZ166 continue to work, all the channels on GB-PVR show the "no signal detected" popup with quality 100% but strength of zero. Solution, stay on 1.0.3.255 (11/02/2006).

[sub]

Do scan in GB-PVR, then zip and attach the config.exe-native.log file. Also attach the ScanChannelsBDA_EZ166 log. Cheers.

[AlanC]

Do scan in GB-PVR, then zip and attach the config.exe-native.log file. Also attach the ScanChannelsBDA_EZ166 log.

I see what you are getting at. If I edit 065.ini (Sandy Heath) to round off the +/- 166khz then the scan will work (Scan-4.BDA attached). The Hauppauge Nova-T still scans as well. I can get the new drivers working if I round off the frequencies of all the channels. Should I do this?
Note that I get some interferrence on the signal round here. It gives errors in the scan. It also is a problem when watching TV as the 'no signal' popup appears with both quality and strength at 100% and it won't go away unless I switch to another channel and back again, or even pull out the aerial lead and put it back (strength drops to zero then normal service is resumed).

[sub]

I see what you are getting at. If I edit 065.ini (Sandy Heath) to round off the +/- 166khz then the scan will work (Scan-4.BDA attached). The Hauppauge Nova-T still scans as well. I can get the new drivers working if I round off the frequencies of all the channels. Should I do this?

Yeah, just do that.