Viewing on PC monitor or TV

[atmassie]

I just wanted to know if their is a way to change from viewing on the PC monitor to my TV. It works on both but i have to go into the GB-PVR config to switch between the two. Or can i view on both at the same time.
Thanks

[HtV]

I guess you have a hauppauge 350 and are using the tv-out on the 350.
I don't know of a way to have both (pc-monitor and tv) at the same time. You would have to use the tv-out on the videocard (if it exists).
But if the 350 tv-out works ok for you I wouldn't go there unless you have a very good videocard. The tv-out on the 350 is hard to beat quality-wise.

[kayak4ever]

I accidentally have the recordings and live TV show up on both the monitor and the TV. If I use vmr-7, or9, I get the display on both screens but if I use overlay it only shows up on the TV. This is a recent changes that happened when I got a new TV and switched from the hauppauge default video decoder to Cyberlink or Nero to eliminate the stuttering. My video card is nvidea 4

I hope this helps

[Azimuth]

Do you have the nvidia drivers installed with the "Nvidia settings" control panel?
If you use the GBPVR overlay mode, it is likely that the the card will output GBPVR through the svideo port when a TV is detected (by default). You should be able to change the output preference to both monitors or whatever combination you wish to use via the Nvidia control panel.

[atmassie]

Thanks for the info that gives me some stuff to try.