DVB-EPG on KabelDeutschland & HVR930c

[newyankee]

I have installed a Hauppauge HVR-930c USB at a friends place. It worked fine after adding the below entries to bda.ini - both can be added to device database (second one for the DVB-T side, untested).

However, the DVB-EPG update (unecrypted channels only) gave me an error after 59 seconds and at a second and subsequent attempts empty listings (=no EPG). Two sets of logs are attached. Is this GBPVR related or does Kabeldeutschland use a non-standard DVB-EPG?

Guido


************
[Hauppauge HVR-930C ©]
TUNING_TYPE=DVB-C
FILTER_TUNER=WinTV HVR-930C DVBC Tuner
FILTER_CAPTURE=WinTV HVR-930C BDA Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[Hauppauge HVR-930C (T)]
TUNING_TYPE=DVB-T
FILTER_TUNER=WinTV HVR-930C BDA Tuner
FILTER_CAPTURE=WinTV HVR-930C BDA Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport
***************

[sub]

Thanks for the entries. I've added them to the master bda.ini file.

You might want to update your bda.ini file to match these entries to make sure the next upgrade goes smoothly.

[Hauppauge HVR-930C DVB-C]
TUNING_TYPE=DVB-C
SHARED_NAME=Hauppauge HVR-930C
FILTER_TUNER=WinTV HVR-930C DVBC Tuner
FILTER_CAPTURE=WinTV HVR-930C BDA Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[Hauppauge HVR-930C DVB-T]
TUNING_TYPE=DVB-T
SHARED_NAME=Hauppauge HVR-930C
FILTER_TUNER=WinTV HVR-930C BDA Tuner
FILTER_CAPTURE=WinTV HVR-930C BDA Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[sub]

For the crash, you might need to capture a minute long 'full ts' recording from one of the channels on that frequency, then make it available on a website for me to download. I can then try running through the EPG update here in the debugger.

[newyankee]

I have captured two .ts samples. Please take a look when you find the time. I have sent you a PM with the links.

Guido

[sub]

Can you see if this patch helps?

[newyankee]

Can you see if this patch helps?

Indeed it does. The EPG has been properly read and appears in the guide. I am supporting the particular installation long-distance, thus I can't tell if everything is 100%, but so far it sounds good.

Thanks a lot for the swift service.

Guido

[sub]

Great.