Aussie Looking for a Helping Hand

[KenAdelaide]

I was wondering if a local Aussie might be able to point me in the right direction?
I am having trouble getting GB-PVR going. Reading the Wiki and the considerable amount of material I can understand much of the more complicated issues but I can’t get started. A bit like I am a good driver but I can’t find where to put the ignition key! Without going into details could some kind sole put their hand up to give me a nudge in the right direction. I have downloaded what I thought was all that was needed and can get up Config but all the options are greyed out. ScanChannel is I think the Analogue while I want the Digital. Hope for just a little help. Ken of Adelaide

[systemshark]

Hello. from the UK.

Inside Config... start with the Capture Sources Tab.

Change The Capture Source Plugin from Analogue to Digital Plugin and press 'Settings'

Either Select your card from the dropdown list or Click the Only show detected devices.

From there select your country and Region for the DVB source....

Leave Common Interface on None and Click ok.

Back to (same) Capture Source. Select a EPG source (to start with I suggest EPG From DVB)

and finally press Map Digital Channels to EPG... it will ask to save the config and move to the Scan screen. When you press Scan it will scan for Digital channels and load them into a Selection list ready to map against EPG data....

Once this is all working your off and running..... Good luck ...