2009-10-27, 10:35 AM
comcast "black box" STB with the on-demand etc.
WinTV7 is using "code set 85" for the IRBlaster, and is working fine, but I am not sure what GBPVR's config is up to.
I have this working fine for WinTV and the DCT700, channel changing on WinTV uses the set top box and the IR-blaster just fine.
GVPBR is configured to use the IR-blaster in the setup for the 1600, but changing channels (arrow key) just changes the tuner up and down, not sending a IRblaster signal to the STB.
How do I determine where the issue is? This was a clean setup of the 1600, and I deleted the old setup for my 350 out before creating one for the new Hauppauge card.
Other report this working. This is the latest GBPVR release.
Thanks!
WinTV7 is using "code set 85" for the IRBlaster, and is working fine, but I am not sure what GBPVR's config is up to.
I have this working fine for WinTV and the DCT700, channel changing on WinTV uses the set top box and the IR-blaster just fine.
GVPBR is configured to use the IR-blaster in the setup for the 1600, but changing channels (arrow key) just changes the tuner up and down, not sending a IRblaster signal to the STB.
How do I determine where the issue is? This was a clean setup of the 1600, and I deleted the old setup for my 350 out before creating one for the new Hauppauge card.
Other report this working. This is the latest GBPVR release.
Thanks!