Help please

Waynesm · 2010-03-15, 01:09 AM

All weekend I have used my Nova Usb2 Dvb-S setup with no problems.
Now, today, I have no reception and a rescan lists no signal.
I have checked the input of the device with a Dick Smith satellite finder and can hear the signal.
Logs attached.
Appreciate any advice.
Thanks in advance.
Waynesm
[ATTACHMENT NOT FOUND]

***sub*** · 2010-03-15, 01:12 AM

Do you have the terminator on the LNB out? I couldnt get channels out of that device unless I had the terminator connected.

Waynesm · 2010-03-15, 01:25 AM

I learnt that from these forums.
In addition to previous post I have reinstalled and my original device (Pinnacle 73e) also does not scan
Waynesm

Waynesm · 2010-03-16, 01:55 AM

As I did not record the previous settings of
LNB LOF1
LNB Switch
LNB LOF2
any suggestions appreciated.
Waynesm

***sub*** · 2010-03-16, 02:45 AM

It depends on the LNB.

I use two different LNBs here. One needs 11300/11300/11300, the other requires 10750/10750/10750.

Jaggy · (This post was last modified: 2010-03-16, 05:18 AM by Jaggy.)

Just in case those don't work I have to set mine to 10750/0/10750

Waynesm · (This post was last modified: 2010-03-17, 02:22 AM by Waynesm.)

Thanks. I now have established that the Wintv 6 software is not working properly, when initially it did. Changing the Usb port can lead to drivers not installed properly messages.
I think that I have a lot more to do.
Cheers
Waynesm

P.s I've had a look and my dish is 11300

Waynesm · 2010-03-18, 01:46 AM

Success.
After uninstalling Capture device, restarting Windows the device drivers were loaded without hauppauge software and reinstalling version 1.3.11 all came to life.
Wintv 6 loaded for access to Remote.
Slimm software reinstalled as well.
All good.
11300 settings worked.
Thanks for advice and I'll work on upgrade over the weekend.
Waynesm