"Name" resets to "Default" when using Update after Recordings, Man-Rec

[erichi]

After adding a recording via Man-Rec, the Name resets to Default when performing the Pending Recordings, Update action.

NextPVR 2.2.6, with NPVR 2.2.6 Patches R2.zip applied on 1-Nov-2011.

Additional note: This seems to be an issue only with Recording Type "Record Once."

[Reddwarf]

But with "Record Once", wouldn't it be easier to just use "Quick Record"?

[sub]

After adding a recording via Man-Rec, the Name resets to Default when performing the Pending Recordings, Update action.

NextPVR 2.2.6, with NPVR 2.2.6 Patches R2.zip applied on 1-Nov-2011.

Additional note: This seems to be an issue only with Recording Type "Record Once."

I tried to reproduce it here, but it didnt do it for me.

What were the exact steps? I went into Recordings, scheduled a 'record once' manual recording, giving it a name 'Test', then went into Settings->Channels, did an 'update epg', then went back to the Recording screen and checked the name. It was still 'Test'.

[erichi]

I tried to reproduce it here, but it didnt do it for me.
I went into Recordings, scheduled a 'record once' manual recording, giving it a name 'Test',

After completing this step, say you want to update the start time. Go back to the entry, select it, hit Enter, then Update in order to update the time. The name is lost, and reverts back to "Default." AFAIK, the EPG is not involved.

[sub]

Ah, right you are. I've found the cause of this and fixed it for the next release.