No Tuner

[Mroctober]

I have two cards, the 1600 and 1255, having the same problem with both. I have the latest WinTV7 installed with the drivers, also have latest NextPVR installed on both pc's.

Setup a recording last night on the WinTV, the tuner was fine when I did it. Woke up this morning and it did not record. Checked WinTV and it said no tuner available. NVR said the same. Noticed the NVPR system tray icon was red, indicating it was recording. Although had not set up any recordings with it. Checked the record folder and there were no recordings

I restarted the NVR recording service and the tuner returned in WinTV and NPVR. This has happened the last few nights on both cards

Is there a conflict between NVPR and WinTV with the newest Hauppauge drivers?

[Zeb]

Hi Mroctober, does your EPG update automatically overnight, and if so, are any channels set up for EPG source DVB/ATSC? If yes to both, then you are probably suffering from a known issue that hasn't yet been fully resolved. Here's a link to a post where sub attached a patch designed to gather more information about this bug: http://forums.nextpvr.com/showthread.php...post466071

Of course you might want to read that entire thread. If you want to install the patch, be sure to follow the Installation Notes in the Current Patches and Getting Started sticky. If the problem occurs again, your logs might provide sub with valuable clues. Unless you're running XP, they should be at C:\Users\Public\NPVR\Logs. However if you just want a workaround, I would suggest setting any channel for which XMLTV listings are not available to EPG source None.

[sub]

I have two cards, the 1600 and 1255, having the same problem with both. I have the latest WinTV7 installed with the drivers, also have latest NextPVR installed on both pc's.

Setup a recording last night on the WinTV, the tuner was fine when I did it. Woke up this morning and it did not record. Checked WinTV and it said no tuner available. NVR said the same. Noticed the NVPR system tray icon was red, indicating it was recording. Although had not set up any recordings with it. Checked the record folder and there were no recordings

I restarted the NVR recording service and the tuner returned in WinTV and NPVR. This has happened the last few nights on both cards

Is there a conflict between NVPR and WinTV with the newest Hauppauge drivers?

You'll need to post the logs so we can check.

[Mroctober]

I turned off the EPG update in the 1255 and left it on in the 1600. This morning the 1600 showed it was recording, 1255 did not. So I guess it is EPG related

[Zeb]

I'm pretty sure that's the same problem as the thread "Having issue with Automatic EPG updates on 3.1.1" Are you able to get a useful amount of EPG data via ATSC?

[Mroctober]

Yes, ATSC works much better than QAM with EPG