2014-05-27, 01:41 PM
I upgraded my PC and did a clean install of NPVR this weekend. I did a lot of test recordings to make sure I had set everything up correctly and found that some recordings were coming out choppy in both audio and video. Checking the recording status, I noticed that often, 2 concurrent recordings would go to the same tuner (I have 3) instead of each tuner recording 1 show and these "doubled up" recordings were of poor quality. These were all manual recordings, so no pre- or post- padding issues. In reading through other posts on the forum, it seems that if I record 2 shows on the same digital ATSC (OTA) channel (i.e. 13.1 and 13.2) in the same time slot, they will use ONE tuner, even if another one is available. Is this correct? I didn't see a solution posted. If I've understood the previous posts correctly, is there a way to set NPVR so that IF another tuner is available, it will be used instead of doubling up on one tuner?
Logs attached
Thank you!
Logs attached
Thank you!