2018-04-06, 02:39 PM
I have three RPi devices running LibreElec v8.2.4 (Kodi 17.6). I will start a recorded show on one TV, then move to another room and try to resume the show. However, I have to disable and re-enable the NextPVR plugin and have it re-down load the EPG channels and content before I can resume the show on the different TV.
This is not new. I posted something similar to this a couple of years ago when I first started using NextPVR. If I remember correctly, the answer was to try X-Newa, but I could never get it to work, so I've always stuck with the default NextPVR plugin.
I don't know if there is a setting somewhere that I need to adjust, or to set or to tweak? Something within either Kodi, the plugin or on the NextPVR server? I would think that there should be a daemon somewhere that runs that would keep checking in with the server to see if there are any updates. Perhaps there is something that I need to enable? Its just getting old having to disable/re-enable the plugin, so I can resume watching what I was watching.
Thoughts?
Thanks
Daryl
This is not new. I posted something similar to this a couple of years ago when I first started using NextPVR. If I remember correctly, the answer was to try X-Newa, but I could never get it to work, so I've always stuck with the default NextPVR plugin.
I don't know if there is a setting somewhere that I need to adjust, or to set or to tweak? Something within either Kodi, the plugin or on the NextPVR server? I would think that there should be a daemon somewhere that runs that would keep checking in with the server to see if there are any updates. Perhaps there is something that I need to enable? Its just getting old having to disable/re-enable the plugin, so I can resume watching what I was watching.
Thoughts?
Thanks
Daryl