(2021-03-14, 04:46 PM)sub Wrote: Was that port still open in your firewall? I just tried that url in VLC with your public address, but it didn't seem to be able to connect.
Maybe it is because i sometimes watch TV with TVHeadend and that URL starts a stream on Tuner 1. How can i select wich of the both tuners will we used when opening that URL?
(2021-03-14, 04:46 PM)sub Wrote: Was that port still open in your firewall? I just tried that url in VLC with your public address, but it didn't seem to be able to connect.
Maybe it is because i sometimes watch TV with TVHeadend and that URL starts a stream on Tuner 1. How can i select wich of the both tuners will we used when opening that URL?
Usually the tuner is chosen by the sat>ip device, and you don't get much say in which it uses. (I think some might support a "&tuner=x" paremeter on the url)
2021-03-16, 04:16 PM (This post was last modified: 2021-03-16, 04:16 PM by Qvex23.)
(2021-03-15, 08:00 PM)sub Wrote:
(2021-03-15, 07:55 PM)Qvex23 Wrote:
(2021-03-14, 04:46 PM)sub Wrote: Was that port still open in your firewall? I just tried that url in VLC with your public address, but it didn't seem to be able to connect.
Maybe it is because i sometimes watch TV with TVHeadend and that URL starts a stream on Tuner 1. How can i select wich of the both tuners will we used when opening that URL?
Usually the tuner is chosen by the sat>ip device, and you don't get much say in which it uses. (I think some might support a "&tuner=x" paremeter on the url)
So the URL i send as PM is working Even via Public IP. Any Ideas why NextPVR wont find channels?
(2021-03-16, 04:16 PM)Qvex23 Wrote: So the URL i send as PM is working Even via Public IP. Any Ideas why NextPVR wont find channels?
I just tried that url again, and it's still not working remotely for me from VLC (using your public URL). If I could get it working remotely, then there is a possibility I can investigate why the scan isn't working.
Basically the device isn't liking something about the tuning strings coming from NextPVR. (the exact same strings are working fine with other SAT>IP devices, so some quirk of the Telestar devices that I'll need to work around)
(2021-03-16, 04:16 PM)Qvex23 Wrote: So the URL i send as PM is working Even via Public IP. Any Ideas why NextPVR wont find channels?
I just tried that url again, and it's still not working remotely for me from VLC (using your public URL). If I could get it working remotely, then there is a possibility I can investigate why the scan isn't working.
Basically the device isn't liking something about the tuning strings coming from NextPVR. (the exact same strings are working fine with other SAT>IP devices, so some quirk of the Telestar devices that I'll need to work around)