Problem with scanning SAT Channels

[olliw]

Hello,

I have a problem with scanning the transponder frequencies
- 11053
- 12633

No station is found on any of these transponders.
According to nrecord.log (timestamp December 05, 2022 / approx. 20:35) the following errors occur on transponder 11053:
2022-12-05 20:35:19.376 [ERROR][45] TS continuity counter indicates missing packets
2022-12-05 20:35:19.383 [ERROR][45] TS continuity counter indicates missing packets
2022-12-05 20:35:19.384 [DEBUG][73] FE: 1 Locked: 1 Level: 134 Quality: 15
2022-12-05 20:35:19.408 [ERROR][45] TS continuity counter indicates missing packets
2022-12-05 20:35:19.409 [ERROR][45] TS continuity counter indicates missing packets
2022-12-05 20:35:19.434 [DEBUG][45] System.OverflowException: Arithmetic operation resulted in an overflow.
  at NShared.TS.TSSectionParser.AddData(Byte[] data, Int32 offset, Int32 length)

The following errors are logged for transponder 12633:
2022-12-05 20:35:30.944 [ERROR][45] TS continuity counter indicates missing packets
2022-12-05 20:35:31.043 [ERROR][45] TS continuity counter indicates missing packets

Possibly this is a similar error as described in this thread: https://forums.nextpvr.com/showthread.ph...447&page=1.

I have attached the log files as an attachment.

Can someone please take a look at this.

Thanks for the support.

[mvallevand]

That problem seems unrelated. If you are missing packets that would primarily be a reception issue. If you get the error consistently on 11053 then sub might be able to look at the full mux capture. You might be able to do that with TS Capture https://www.tscapture.com/ but the errors could get in the way too.

Martin

[pantentshadow]

Hello,
I would like to know how to set up the scan for the sat channel.
I am using Astra 2.8E and I would like to know what to put in the three boxes.
I am trying to follow the Astra 2F (28.2°E) - All transmissions - frequencies - KingOfSat site.

[sub]

I would like to know how to set up the scan for the sat channel.
I am using Astra 2.8E and I would like to know what to put in the three boxes.

Do you mean the LNB settings? This would depend on the type of LNB you're using. The most common "universal" LNB would work with these:

LOF1=9750
LOFSwitch=11700
LOF2=10600

[pantentshadow]

Hi
Thank you for the response, I am only getting half the channel by using the old sky min-dish stander.
I would like must I change the LNB settings to get more channels.
I how would find the LNB settings LOF1, LOF2 are they on the dish.

[sub]

I think they're often on the LNB, which is at the end of the arm on your satellite dish.