Help needed with Comskip

[Box8489]

Please allow a question from a totally newbee into Comskip?

Is it possible to have Comskip marking commercial parts based only on logo detection?
At my favorite channel, there is always a steady logo during the show and never a logo during commercials.
It seems from the log file that I am detecting the parts with logo's correctly but I have only a com part in the beginning and in the very end - nothing in between.
So is it possible to remove all the other fancy detection methods and using only logo detecttion ?

Any help will be appriciated:
Michael,
Denmark

[erik]

Try to use these changed settings in your ini file, and then report back.

connect_blocks_with_logo=0
delete_show_before_or_after_current=0
delete_show_after_last_commercial=0 ; could be set to 1 if this was correct
excessive_length_modifier=1 ; This is the most important change
ar_wrong_modifier=10.0 ; Enable AR detection for more robustness

If the black frames are not on the commercial boundaries you can always add cutting on logo boundaries (see the tuning.rtf manual)