Nvidia Tv Out not full screen

[cmgeek2]

This is very annoying. I'm using an old Creative TNT2 video card for the s-video out function. The problem is the output is not full screen. It leaves black stripes along the left and right side. I googled this and found most people have this problem and tvtool.de fixed it.

I ran tvtool and the screen started jumping all over the place. I couldn't even see the picture. Anyone else have any ideas?

[ShiningDragon]

One Question: Which ForceWare/Detonator Version are you using? With the newer driver, you can correct this problem within the drivermenu.

[Koenie]

I found out that the only setting at which my 6200 wants to go full screen is 720x576 (full PAL, might be full NTSC in your case).

BTW this setting also produces the best quality picture.

edit: hve to updte my profile I see as it still has the old AIW

[cmgeek2]

One Question: Which ForceWare/Detonator Version are you using? With the newer driver, you can correct this problem within the drivermenu.

This card is so old I can't even find drivers for it. I had to settle for the ones with XP SP2. I went to nvidia.com and downloaded the TNT2 drivers and it said no devices found when I tried to install it.

Not sure what a forceware/detonator is?

[ddrawley]

Check the driver archive section on the NVidia site. I think you will have to go back to 6x.xx version or below for a TNT2. I have done it but don't have it right in front of me.