Channels with 2 consecutive numbers the same...

[joshley]

Sub... if I check the 'Send OK after transmission' option, it works fine the first time, and if I enter, say '23', my STB flashes THREE times, but thereon after it only flashes TWO times (i.e. Enter is no longer being sent). If I leave GB-PVR and restart the recording service it works first time again fine, but enter is no longer sent from the USB-UIRT after that. I think this could be the cause and potential solution to my problem; that option only works the first time.
Is this fixable?

[sub]

I've just check here, and "enter" is sent every time.

[joshley]

Sub, just checked again, sends only on first attempt.. don't know what to do! It works on the first attempt and not on second, I know it has nothing to do with the remotes because if I restart the GB-PVR Recording Service without pressing ANY other buttons it will work again first time, but it won't work again thereafter until I restart the service again. Dunno what else to report!

joshley

[sub]

Can you email your gbpvrrecordingservice.exe.log file to me at support@devnz.com

[joshley]

Sub,
I've emailed you the logs, and by looking at them it does appear as though the ENTER command is not being sent after the first time. However, even if this was resolved, it would not solve my problem in particular because channel numbers like 922 and 11 would still not work, because there would be no enter command sent between the identical consecutive digits. It is more solidly looking like Girder for me!
joshley

[sub]

You didn't attach your logs to the email.

I still think your problem would be solveable by adjusting the ir repeat count and inter digit delay.