Dvico Fusion 5 USB causes BSOD

[Torque]

I just got the Dvico Fusion 5 USB HDTV device.

I installed it like Daphatty's config guide in the wiki (ofcourse, using the dvico USB ATSC device). It works in GBPVR only one time before it bluescreen's my test box. Reboot, go back into GBPVR, watch another channel, exit back to main menu, try to watch the same channel, get the same bluescreen. Bluescreen says driver irq not less or equal, referencing bluebird2.sys.

The Dvico app works fine, i can open and close it, change channels as much as i want, hasn't crashed yet.

Any ideas?

The logs are attached below:

[Torque]

A little more info. If I go into the Guide and set it to record a show, then start watching it as it's recording, it works fine. I can stop and start the recording as much as I want, exit to main menu, go back in and start the recording all over again, no problem. Just trying to watch Live TV "a second time" is where it has problems.

[crickert]

A little more info. If I go into the Guide and set it to record a show, then start watching it as it's recording, it works fine. I can stop and start the recording as much as I want, exit to main menu, go back in and start the recording all over again, no problem. Just trying to watch Live TV "a second time" is where it has problems.

That's exactly what I am experiencing. When I try to watch Live TV a second time, it will either give the object reference error or my box will reboot. I am very confident it is a GBPVR glitch because I have been using Dvico's software without any problems. Torque, for testing purposes, what are your results with Beyond TV 4?

[Torque]

Crickert, I didn't try BeyondTV 4, but according to a few people on HTPCnews, it works fine with BTV4.

See my lengthy post #14 at:
http://forums.nextpvr.com/showthread.php...stcount=14