PC don't boot anymore

[stf]

Changed the settings in the recording source to High Quality to see if that would make the image better. First problem is that it would not save to High, would always stay at medium so i decided to set Medium with the same settings as high (high bit rate, etc). After restaring the GBPVRRecordingService, the PC crashed (locked up) so i pressed reset, guess what, it does not boot anymore, it hangs at the Windows XP startup.

Booted in safe mode, changed those settings in the direct.ini file (because i could not start the Config application and then I rebooted normally and the lock up still occurred. This was last night and i had to travel today so i can't troubleshoot remotely. I am sure it must be something around the Hauppauge PVR150 drivers or something that when it loads, it freezes the computer.

Does someone experienced this problem before?

Stephane

[pBS]

sounds like a pc prob, not a gb prob but if you boot into safe mode [hit F8 while booting] no drivers will load so you can see if the drivers are it...
the recording profiles don't come into play until you start recording something, so that couldn't be keeping it from booting..

just a thought, check your winxp\system32 dir for a config.xml file and delete if found...