Tuning in tv channels

[RLea]

Hi,

I have installed GB-PVR and true to everything I have read everything was nice and easy and just worked ... however there was one exception. I have been unable to actually tune in any tv stations, I have a listing of all the frequencies, but nowhere to enter them.

The tuning assistant has picked up a few, but not in the right place, and not all of them.

I am in NZ, just using free to air tv signals (TV1=45Mhz, TV2=62Mhz, TV3=217Mhz, C4=196Mhz, Prime=783Mhz, Trackside=751Mhz, Maori=655Mhz)

Can anyone point me in the right direction so that I can actually get the info to GB-PVR.

Thanks
Ryan

[bluesxman]

The Wiki is a good place to start looking for info.

The page on setting up channels is here:
Channel Mappings.

[sub]

If you use the tuning assistant, and scan using NZ/Cable, it'll scan a much wider range of frequencies and find all the channels for you. Use these same settings on your capture source.

[skippy_nz]

Hi,

I have installed GB-PVR and true to everything I have read everything was nice and easy and just worked ... however there was one exception. I have been unable to actually tune in any tv stations, I have a listing of all the frequencies, but nowhere to enter them.

The tuning assistant has picked up a few, but not in the right place, and not all of them.

I am in NZ, just using free to air tv signals (TV1=45Mhz, TV2=62Mhz, TV3=217Mhz, C4=196Mhz, Prime=783Mhz, Trackside=751Mhz, Maori=655Mhz)

Can anyone point me in the right direction so that I can actually get the info to GB-PVR.

Thanks
Ryan

if you go to http://www.lincrad.co.nz/transmitters.htm you should be able to find the closest transmitter to you - then when you have that transmitter - take a note of the trasmit channel number - this is what you can use to tune in GBPVR - thats all i used and got all the channels you listed.

cheers
Skip

[RLea]

As expected, the problem was me missing something simple. All channels are now in and everything is working fine.

Thanks for the quick replies.