PVR-250 IR Blaster Problems

[barrow]

Hello,
I have the PVR-250 Bundle that comes with the IR Blaster. I searched throughout the forums here for help and elsewhere but all I could find were people with the PVR-150 Blaster.

I figured that I could use the HaupBlast utility to send signals with my IR Blaster, but when I try to watch live TV I receive the following message:
'The application has failed to start because HCWIRBLAST.dll was not found. Reinstalling the application might fix the problem'.

My question is this. Does anyone else have this bundle? Did you have success getting it to work with GBPVR, and how?

Thanks,
Barrow

[sub]

The PVR250 doesnt come with an IR Blaster. It does come with an IR Receiver for its remote, but no blaster.

[barrow]

The PVR250 doesn't come with an IR Blaster. It does come with an IR Receiver for its remote, but no blaster.

I originally was unsure whether it could both send and receive signals so I asked in another thread. A member pointed me to this page. It says it includes "Infra-red remote control transmitter and receiver".

An error on their part perhaps?

[sub]

You need to need to read it as "Infra-red remote control transmitter" (aka the remote) "and receiver" (aka the bit that plugs into your PVR250 to receive the IR signals from the remote).

[barrow]

You need to need to read it as "Infra-red remote control transmitter" (aka the remote) "and receiver" (aka the bit that plugs into your PVR250 to receive the IR signals from the remote).

You're 100% correct. Thanks a ton.