2008-02-12, 10:20 AM
Hi,
I had problems setting up more than one channel, PVRX2 showed only one and I could not add more channels. So I uninstalled gpbvr, deleted the gbpvr directory (with the old database) and installed gbpvr again.
With that fresh install of gbpvr 1.1.5 on a Vista I have configured everything like it shoud be (i think so): capture source is set up, all channels configured. I used SQLSypLite to check if the channels are set in the gbpvr.db3 file and they are set correctly. The mapping is correct too.
But: the PVRX2 (and the GBPVR too) do show only one channel and in Manual recordings it shows only this channel too. So, it seems to me that PVRX2 does not read the database or uses an old version of it. There are no error messages in the logs.
Any hints?
I had problems setting up more than one channel, PVRX2 showed only one and I could not add more channels. So I uninstalled gpbvr, deleted the gbpvr directory (with the old database) and installed gbpvr again.
With that fresh install of gbpvr 1.1.5 on a Vista I have configured everything like it shoud be (i think so): capture source is set up, all channels configured. I used SQLSypLite to check if the channels are set in the gbpvr.db3 file and they are set correctly. The mapping is correct too.
But: the PVRX2 (and the GBPVR too) do show only one channel and in Manual recordings it shows only this channel too. So, it seems to me that PVRX2 does not read the database or uses an old version of it. There are no error messages in the logs.
Any hints?