Setting up Multiple lineups with Schedules Direct

[rj_lutz]

I am switching to GBPVR from another program for its HDHomeRun support.
I have an HVR1600 and a HDHomeRun, and am using Schedules Direct for EPG. In trying to specify the lineups for each capture device, I found the following post by Sub in the v1.0.16 survival guide (now closed):

Multiple lineups with Schedules Direct
For those that have multiple lineups, there is one trick your need to be aware of. When setting up the capture source, in the email field you can do the following to get it to use the channels from only one lineup:

blah@somewhere.com;DISH501:-

This is a semi-colon followed by the lineup code. This lineup code can be seen on the SchedulesDirect website (shown in the URL when you click the 'edit' button on a lineup).

This having to enter the semi-colon + lineup code is bit complex so I'll eventually add some drop down box that shows the list of available lineups downloaded from the user's account, but unfortunately I'm running a bit short on time so cant do this at the moment.

My question is concerning the lineup code. When I click the 'edit' button on a lineup, I don't see a 'code' anywhere, and I'm wondering if Schedules Direct has changed since the above post. I tried using the "Type" listed ("LocalBroadcast", "Cable", "CableDigital") but it didn't produce any channels for me. It will work if I don't specify the semicolon and extra string, but
I get the entire list of channels from all lineups, and if I delete the extras, they just come back when I update the EPG.

Any help would be appreciated.

[Carlito]

The lineup code is the code after /edit/ in the url
so it would be something like
http://www.schedulesdirect.org/lineups/edit/0000000:-
where 0000000 will be your account number

EDIT:
ok, i just added a new lineup to make sure i wasn't bull***in' ya. I see what you're saying now...
the only difference in my lineups is instead of the '-' on the end the second lineup has a 'X'

I haven't tried using the double lineup myself, but maybe just specify everything after the /edit/ and see if that works

[rj_lutz]

Thanks Carlito, you cleared it up for me. I didn't understand that the code was part of the actual URL, not in the page somewhere. Rereading Sub's post now makes sense, and I was able to use the code to update a specific lineup for one of my capture devices. Thanks a lot for your help!

[sub]

I didn't understand that the code was part of the actual URL, not in the page somewhere.

It used to be on the page itself, making it easier for people to find, but they removed it.