No EPG info after moving from analog to digital

[tasan]

So I've been running PVRX2 just fine for the last several months with my new hvr-1600 on the analog side. Everything was just like it was with my 150. I installed my antenna on the roof this weekend and now get good signal for digital, so I switched over to the digital tuner on the card.

The problem I'm having is pulling EPG data for the extended digital channels (and I'm not totally sure I'm pulling the right data for the base channels). I first went to ShedulesDirect and deselected all the analog channels and selected the digital channels, then saved. Then I opened config and hit the edit button on my capture source. I changed to Digital Recording Plugin for Recording Service, and added channels to map the new digital extended channels to (I had 10 analog channels, and left those in there to map the new base digital channels to). Then I hit the "Map digital channels to EPG channels" button, and successfully scanned all the channels in my area. I went one by one and mapped each channel to the corresponding entry in the channels list and hit OK. Back on the Edit Recording Source window, I hit the Empty EPG button and then the Update EPG button. I then loaded PVRX2 and there is no data for any of the extended channels, only the original base channels. Anyone have any ideas?

[tasan]

Just a thought, but one question is do the channel names have to match what SchedulesDirect lists for the channel? For example, in the pic below I have channel 14-3 KETHDT3, but the channel I mapped it to is JCTV, which is the channel's "name". Should I have mapped it to a channel labeled like SchedulesDirect shows instead?

[tasan]

Here's my Edit Recording Source window, with a sampling of my channels. KRIV was an existing analog channel I mapped to the -1 of the digital version, and KPRC Weather is a new one I added, which corresponds to the KPRCDT2 in the image above.

[whurlston]

If you added the channel manually, you will not have guide data for it. When you update the EPG, GBPVR will automatically add the new channels from your SD lineup. You should map to those channels. If you scroll through the list, you should see a channel named KPRCDT2. To rename a channel, use the "Channels" tab in config.