No Channels found after mapping scan?

[excx]

I know this is a familiar problem. My scan DOES show a signal strength and quality unlike another post where it was not registering. None of the channels show up as found though?

I initially had the problem where I could not get it to scan, receiving the error msgs. cant find your card or the make sure your card is config. properly or already in use. I uninstalled/reinstalled everything now have the above prob.

ver. 1.4.7
xp sp 3
ATI HDTV WONDER

any help is appreciated, thank you

[sub]

Can you try scanning again, then post the config.exe.log and config.exe-native.log?

[excx]

Can you try scanning again, then post the config.exe.log and config.exe-native.log?

I do have other versions of the logs, due to my reinstalling? this is the ver.1

[sub]

Ah, sorry - I hadnt notice your original mentioned the ATI HDTV Wonder. Unfortunately this device is the one BDA capable device that I'm aware of that doesnt like GB-PVR. We've never had any success scanning with this device. Something about it's drivers are quirky, causing it to not like the way GB-PVR does its thing.

[excx]

I do have other versions of the logs, due to my reinstalling? this is the ver.1

here is ver. 3

thanks again.

[excx]

I will fiddle around with it a while, let me know if you recall anything later? thanks

[sub]

If you do a forum search on 'HDTV Wonder' you should be able to find some comments from previous users who have manually setup channels by typing tuning requests (a relatively difficult task).

[excx]

If you do a forum search on 'HDTV Wonder' you should be able to find some comments from previous users who have manually setup channels by typing tuning requests (a relatively difficult task).

sounds labor intensive, I will give it a try..

[8ace]

sounds labor intensive, I will give it a try..

it's not the destination, it's the journey ... and we *love* to travel