ATSC/Hvr2250 - no channels found

[Datphysh]

So I come to you wise guru's on my knees, begging for your assistance.

I have a hvr2250 card which is not able to pick up any channels on it's ATSC scan. Wintv7 picks up 17 different channels. GBPVR sees 0. I have been all over the forums and the wiki and can not figure this one out for the life of me.

I am running windows 7, gbpvr version 1.4.7, and current drivers from Hauppauge.

I followed the guide in this thread to the "T" so to speak.

I tried swapping the PsiParser.ax file with one from the survival guide (last version survival guide?) just to try it, and swapped it with the PsiParser.ax from the Wintv7 directory and still have no results. I have since returned to the original PsiParser that was install with 1.4.7.

I have attempted to retrieve the exact frequencies that wintv7 uses via the method of this thread here, specifically the posts by JavaWiz (post 59 and 61) even though they are for QAM instead of ATSC/OTA thinking that perhaps the method should at least be similar. However the code line doesn't return any exact frequencies. Actually no results at all.

I have tried editing the all.ini file (located in the /BDA/ATSC directory) with frequencies I found here as a desperate effort and still no results. I have returned the all.ini to it's original state. Was it the right file to change? I don't know, but like I said, I've reached desperation and am trying anything at this point.

I have another card, an HVR1800 that I had installed and had the exact same problem with although that one could pick up analog channels, I have not tried analog with the HVR2250. I swapped the HVR2250 for the 1800 with the idea that if I could get one of them to map I could copy the frequencies/file for the second one. It is my intention to run them both when this is finally completed.

So here I am, humbly requesting any thoughts, ideas, hopefully solutions.
If I need to provide any logs other than the config log please let me know.

[sub]

Can you try doing a scan, then post your config.exe.log and config.exe-native.log files? The native logs are missing from those previous logs.

[Datphysh]

Sorry for the lack of inclusion of the native logs. attached here is the entire log folder after per your request I just attempted another scan.

[sub]

2010-02-05 11:31:07.976 VERBOSE video decoder filter: Microsoft DTV-DVD Video Decoder

Try setting another MPEG2 video decoder. This decoder has been known to lead to scanning not working. Remember to ok out after changing the decoder, before scanning, to make sure the new decoder is used.

If it still doesnt work, repost those logs. I only need to those two specific log files.

[Datphysh]

Success!! Scan isn't finished yet but it is already picking up channels. merely changing that decoder.... I never would have thought of that.

Thanks sub.

[sub]

Great.