2005-03-27, 05:14 PM
Hi guys,
thank you for your replies. I use the german DVB-T and scan for all channels there. The frequencies that are shown in the Hauppauge software are also shown during the scan, therefore i assume no problem there.
I tried to completely remove the hauppauge drivers/software as well as the gb-pvr software and do a fresh install. I also removed all left hauppauge entries I could find in the registry. But I had no success. After the scan I always get the message that no channels were found. Upon leaving the window where I could map channels I always get an exception that crashes gb-pvr.
What am I doing wrong?
Any more advice appreciated.
Greetings and happy easter
Jui
thank you for your replies. I use the german DVB-T and scan for all channels there. The frequencies that are shown in the Hauppauge software are also shown during the scan, therefore i assume no problem there.
I tried to completely remove the hauppauge drivers/software as well as the gb-pvr software and do a fresh install. I also removed all left hauppauge entries I could find in the registry. But I had no success. After the scan I always get the message that no channels were found. Upon leaving the window where I could map channels I always get an exception that crashes gb-pvr.
What am I doing wrong?
Any more advice appreciated.
Greetings and happy easter
Jui