2017-07-25, 02:44 PM
With 4.0.4 DVB-T radio channels aren't working properly.
Starting a radio channel I get silence, though the stream is being saved to the "Temp" directory fine. If I first view a tv channel and then switch to the radio channel it sometimes plays the audio. I have attached log extracts of doing both.
Switching to another radio channel results in silence again until I switch to a tv channel and back again. Sometimes changing channel from a radio channel just hangs NPVR.
If I select the "use legacy TS..." option then some radio channels will start playing immediately without having to view a TV channel first and when changing between radio channels, and using the "switch to a tv channel and back to radio" trick results in a few seconds of audio and then silence. (stream is still recording to disk in Temp just as before)
Additionally there's no OSD at all showing on these radio channels (completely black window).
I'm running Windows 7 64 bit.
Starting a radio channel I get silence, though the stream is being saved to the "Temp" directory fine. If I first view a tv channel and then switch to the radio channel it sometimes plays the audio. I have attached log extracts of doing both.
Switching to another radio channel results in silence again until I switch to a tv channel and back again. Sometimes changing channel from a radio channel just hangs NPVR.
If I select the "use legacy TS..." option then some radio channels will start playing immediately without having to view a TV channel first and when changing between radio channels, and using the "switch to a tv channel and back to radio" trick results in a few seconds of audio and then silence. (stream is still recording to disk in Temp just as before)
Additionally there's no OSD at all showing on these radio channels (completely black window).
I'm running Windows 7 64 bit.