PVR 500 MCE live tv blocked when recording

[s.eigenmann]

For the PVR 500 Card I have configured two capture sources. For both I have chosen PVR500 MCE with FM tuner (maybe this is wrong?) One setup for device #1 and the other for device #2. the tuners have been configured manually (Channel Name and Channel).

Then I started a recording (this works fine). As long as the recording runs, live tv is not possible. It shows a message in the menu, that live tv does not run, because there is only one tuner.

What could i do now?

[sub]

Is the channel you're trying to record available on both capture sources?

Both capture sources should have the EPG set up independently, with the specific channels enabled.

When you schedule a recording, GB-PVR will look for an available capture source that has the specified channel.

[s.eigenmann]

yes, both capture sources are setup independently, but with the same channels. As soon as one recording is running, i can not look live tv at all. There is immediately a message that there is no second tuner available. In the Hardware setup (device Manager, both tuners are visible and enabled. They are setup with Hauppauge drivers for Windows MCE: Name: MCE_CD_V25.ZIP, Size: 3.5Mbytes, Version: 2.5, Date: March 23, 2005).

Is it possible, that Windows MCE is interfering with the GBPVR Config in a way?

The behaviour is the same when i look live tv and start GBPVR as a second instance again and try to look live tv there -> the same message appears in the Menu.

[sub]

Setup a test that shows this, then email the log files to me at support@devnz.com and I'll take a look.