Help: Girder Event changer plugin

[*Dean*]

Giday.. am new, both to the forums, and to GB PVR.

Am up and running the App, and have the guide data all working, and can record etc.

However, now I am trying to remotely change channels on my Sky Sat receiver. I have a USB-UIRT, and realise that GB PVR can directly drive it, but I don't want to use this feature, as I also use Girder to control a few other IR devices, and when Girder uses it's USB-IRT plugin, it wipes out support for it in GB PVR, and vice-verca.

I have made up a working GML file in girder to control my Sat receiver, and tested the IR commands from Girder and they work fine.
They are events labled '0 thru 9'

Now, I feel the best option for me to change channels from GB PVR, is to use the GB PVR girder channel changer plugin.

However, here's where things have turned to custard, as damned if I can get it to work.

Would some kind sole have some kinda 'guide' as how to setup the girder channel changer plugin?

In girder(3.3), I have the 'Internet Event Server' plugin enabled, but it doesn't seem to be communicating with GB PVR 'at all'

I can however use the girder event.exe command from dos command prompt to trigger my learned commands.
eg. event 1 -silent changes my Sky Receiver to channel 1.

Any help really appreciated!
Thanks in advance..

..Dean..



..Dean..

[*Dean*]

OK... I after a lot of reading, I found a thread that explains what I need to do.

I didn't realise that a script was required inside Girder, and wasn't aware of the tuner commands that GB PVR sends to Girder.

I shall try again, now that I am armed with additional info.

..Dean..