Zap2it EPG update problems

[broncos21]

Hi just installed gbpvr. Windows XP, Service Pack 2, 1.2 Celeron, 256 mb ram, haupaugge wintv-pvr 350.

I signed up for zap2it by logging on to http://labs.zap2it.com. Every time I try to update my epg I get the following error:

Your EPG Source does not appear to be configured correctly. Please check the EPG Source Settings and try again

I've turned off my firewall on XP and even directly connected my modem to the computer as opposed to through my router and I still get the error.

Any ideas?

Thanks in advance.

[newb]

I also installed gbpvr yesterday and had major problems with zap2it. Read this forum, there are other people with problems (firewall, strange dlls, etc.) Look at your config.log.txt file, it may give you some clues. In my case, I was just getting a timeout after 2 minutes of unsucsessful requests. I tried many things unsuccessfully and at some point found out that the behavior is identical when I completely disconnect the internet access. Ultimately I got it to work by physically removing an unused wi-fi card, and removing unused protocols from the lan config. Seems that there's a bug in gbpvr (all other software finds internet just fine), and that's further obscured by the very generic failure message...

Anyway, check your config.log.txt file, and look thru this forum for suggestions.