Bug in Conflicts code v94.13

[steves]

Sub,

Don't know if you've fixed this in the latest v95 version.... (apologies if you have)

I've found a bug in the way conflicts are handled when you have 2 (virtual) tuners.

My setup has one physical PVR150, configured as 2 tuners:

1: Telewest (cable box controlled by USB-UIRT)
2: Terrestrial (normal channels off Antenna no changer required, used for Channels 1 - 5)


Situation:

1) Do a reoccuring schedule for something on tuner 2 (e.g. the daily daytime rubbish on Channel 1) I call this SHOW A. It's on everyday Mon-Fri same slot.
2) Schedule reoccuring SHOW B the similar daytime rubbish on Channel 3, scheduled as a *deliberate* conflict. (again this should be on Tuner 2)

What I see in SCHEDULED_RECORDINGS table.

SHOW A is scheduled correctly all shows scheduled on Tuner 2 Status 0.

SHOW B is scheduled INCORRECTLY all shows scheduled on TUNER **1** Status 5 (I assume 5 means conflict).

Even if I remove the conflict the Status changes OK but the Tuner remains 1 (i.e. incorrect).

Repeated above experiment but removed one of the SHOW A schedules (e.g. Wednesday) before I scheduled the SHOW B slots.

Results: All the show Bs are scheduled wrong except for the "Wednesday" one where I pre removed the conflict.

This results in shows not recording (coz the tuner's wrong).

You've probably spotted this already though....


Cheers

Steve

[sub]

In v0.95.11, there has been a couple of bug fixes for conflicts when the user has more than one capture source on a single device.

Its 6:25am, am I'm not really up to thinking about what you've written to give you a more detailed answer.

[steves]

Yeah thought it was a bit early in NZ! Shouldn't you be in bed? Your dedication never ceases to amaze me.

If I can get some time on the box I'll try an upgrade (scary via the modem)...and let you know. (if it's not fixed at least it's documented... ;-))

Thanks for all the hard work!

Steve