Setting up channels from 2 sources ?

[dart394]

setup:
pvr-150 using its remote blaster
tuner input = ota antenna
svideo/audio = Direct STB

Most of my channels come from my Direct TV STB which requires me to use the ir blaster to change the channels. Got this working.
I also have 6 channels that I need to get OTA from the tuner input. Got this working.

Is there a way that I can get both of them to work at the same time ?
In wintv2000, I set up the stb channels under ir_blaster and the ota channels under tuner and they co-exist rather well (-:
In the gbpvr configuration I only see options for external channels or internal tuner, no obivious way (to me) to configure them both together. I know that I am probably overlooking something but can not get it.

Any assistance will be appreciated !

Dale

[sub]

Just create two capture sources and it'll automatically take care of the rest.

[dart394]

Just create two capture sources and it'll automatically take care of the rest.

I have been in the other room playing and just figured that out. Thanks for the prompt reply though !
I am still working through a problem with the epg duplicating my ota channels and not populating the epg on my sat channels. I did not have a sat profile on zap2it and corrected that and am downloading a new epg as I type.



Getting closer.

Thanks again for the assistance. If I get stuck, I will post back.

Dale