Auto aspect ratio with 4/3 analog recordings

[frederic]

Would it be possible to choose (in the config) what to do with 4/3 analog recordings when using auto aspect ratio (do a center cut for instance).
Most of the time the recording contains 16/9 data and I end up with small image (1/9 of the screen surface) on my 16/9 screen.

I tryed to map the FULLSCREEN entry (or another) of my irremote.ini to f7 but no luck. I restarted gbpvr, rebooted the pc, ... but the changes in the irremote.ini don't seem to be taken into account. Is this because I use direct access to the remote?

I really need to have one of those solutions working (or a better one if you have one). I think the first one would be the best...

[stefan]

Would it be possible to choose (in the config) what to do with 4/3 analog recordings when using auto aspect ratio (do a center cut for instance).
Most of the time the recording contains 16/9 data and I end up with small image (1/9 of the screen surface) on my 16/9 screen.[/QUOTE]
Auto aspect ratio does not work with analogue recordings. I think that if you choose another aspect ratio than auto, gbpvr will remember that aspect ratio for the next time. Not sure about that, though.

I tryed to map the FULLSCREEN entry (or another) of my irremote.ini to f7 but no luck. I restarted gbpvr, rebooted the pc, ... but the changes in the irremote.ini don't seem to be taken into account. Is this because I use direct access to the remote?

Yes, irremote.ini has no effect at all when using direct access. That is what direct access means

I really need to have one of those solutions working (or a better one if you have one). I think the first one would be the best...

I'd try to switch to not using direct access and then map one of the buttons to F7.

[zehd]

Check out this page for a tip or two

http://gbpvr.com/pmwiki/pmwiki.php/Tips/AspectRatios