EPG will not do initial update

[nv40]

I have just done a fresh install of windows xp sp2. I installed gbpvr, and when i try to set up my capture source (first one, i have 2) it says it's contacting zap2it, and then after a few minutes, i get a big msg with an OK button at the bottom. The message starts off with:

Your EPG source does not appear to be configured correctly. Please check the EPG source settings and try again. System.IO.invaliddataexception. The magic number in GZip header is not correct. Make sure you are passing in a GZip stream.

:it goes on giving system.io.header errors further down, but I wasn't sure if i needed to type all that in. As anyone seen this, or know what could be going on?

[Zathras]

nv40,

Others have experienced similar errors and SUB made a "sticky"
post at the top of the support forum titled "v0.99.5 survival guide".
http://forums.nextpvr.com/showthread.php?t=22656
Towards the end of that thread (titled: Some zap2it users having problems with EPG updates) he discusses a patch which may help you fix the problem.

Hope it helps, Kevin

[nv40]

nv40,

Others have experienced similar errors and SUB made a "sticky"
post at the top of the support forum titled "v0.99.5 survival guide".
http://forums.nextpvr.com/showthread.php?t=22656
Towards the end of that thread (titled: Some zap2it users having problems with EPG updates) he discusses a patch which may help you fix the problem.

Hope it helps, Kevin

I'm sorry for making a thread when this info appears available allready. I somehow overlooked it. Thank you for the info...i'm going to work with that and see what i can get done.