2009-02-15, 11:15 AM
Since my harddisk completly chokes if a postprocessing runs concurrent with a recording I have installed Zehdâs PostProcessing.bat with deferred Transcoding and have it run late when no recordings normally occur. Works great except for one problem:
While transcoding, the second of two back-to-back recordings always comes out with a 25-27 seconds total length .avi file (the original .mpeg file is ok)
At first I suspected that it was because gbpvr would use the second capture device since it's first choice was busy, so I swapped the order of the cards in config-app, but strangly the result is the same!
I'v attached the files that might give a clue of what's going on.
Does anybody have a solution?
While transcoding, the second of two back-to-back recordings always comes out with a 25-27 seconds total length .avi file (the original .mpeg file is ok)
At first I suspected that it was because gbpvr would use the second capture device since it's first choice was busy, so I swapped the order of the cards in config-app, but strangly the result is the same!
I'v attached the files that might give a clue of what's going on.
Does anybody have a solution?
"I'd rather have a bottle in front of me than a frontal lobotomy"