I'll give up...

[sub]

I mean lines like this:
2011-01-26 01:41:37.390 [DEBUG][1] PlaybackPositionHelper.GetLastPlaybackDate(D:\WinFast WorkArea\American Hot Rod\American Hot Rod_20091004_15001600.dvr-ms)
2011-01-26 01:41:37.390 [DEBUG][1] PlaybackPositionHelper.GetLastPlaybackDate(D:\WinFast WorkArea\Neuvottelijat\Neuvottelijat_20091013_23300030.dvr-ms)
2011-01-26 01:41:37.390 [DEBUG][1] PlaybackPositionHelper.GetLastPlaybackDate(D:\WinFast WorkArea\Neuvottelijat\Neuvottelijat_20091027_23300030.dvr-ms)
2011-01-26 01:41:37.390 [DEBUG][1] PlaybackPositionHelper.GetLastPlaybackDate(D:\WinFast WorkArea\Myytinmurtajat\Myytinmurtajat_20091028_23300035.dvr-ms)
There is now lot of them. Earlier I didn't noticed so many lines.

You can ignore this. It's not a problem. This happens because the Recording's screen is checking if the file's it's showing have been played before. (the next release will show a small graphic next to recordings that have been played.

The problem is present with "default" too, but some tests vent well with it. But i'd like use ATI display card capability drive audio to TV via HDMI. Other sounds should use
normal sound card. And again, this setup works with Gb-pvr perfectly. I have set ATI sound driver to "default" (which causes, that no any sound, if TV not on), but it would
not either helped.

Sorry, I'm out of ideas on this one.

[jki]

Only way to watch recordings with Npvr, is do some transcoding. If I use PostProcessing.bat to change file format to .avi or .mpeg, audio sync remains ok. But, if I remove
original .ts file, it disappears from recordings list too and have to play only from "videos". Think, that is not right...
In config.xml:
<AutoRemoveMissingRecordings>false</AutoRemoveMissingRecordings>
<CheckForRenamedRecordings>true</CheckForRenamedRecordings>