Decoders setting crashes "NextPVR has stopped working"

[ljbooth]

Hi, I'm relatively new to NextPVR. I recently installed the program and had it working fine, a couple days ago I upgraded to version 3.8.3 and since then I have not been able to get it to work... when going in to the Decoders setting the program crashes (windows message saying "NextPVR has stopped working"). Same issue happens on the DVD setting. I have tried going through troubleshooting and similar issues with the Decoders and DVD setting menus, but have had no luck. I tried full uninstall of the program and a clean Install, but same issue occurs. Also have been through reinstallation of SAF filters, have tried previous versions of NextPVR, but still no luck.

Log file is attached. Any advice/assistance would be appreciated.

System information:
Windows10 laptop
Hauppauge tuner

[sub]

It'll be a bad decoder registered in the system, and the process would crash when you ask Windows for the name of the decoder. We've seen a couple of users with this over the years. I can't remember how we tracked down what the bad decoder to remove it.

[mvallevand]

For me I get this if I have two monitors enabled. I disconnect monitor two and it works.

Martin

[ljbooth]

I dont have any external monitors... just the laptop screen. Thanks for the suggestion though.