WOW with quick question about Girder support...

[sub]

Yes, I have a set of windows message that can be used as an alternative to keystrokes. I'll post them after work when I'm back in front of my source code.

After reviewing them, if you need additional messages let me know and I'll add them. Currently the messages map pretty much to the keystrokes, but there is nothing to stop adding additional messages such as 'go to the TV Guide screen' or 'exit GB-PVR'.

[msm]

Fantastic. If only all software had this type of support i'd..well i'd proabably never get anything else done 'cos i would never have to wait for a response....

Once I have the .gml done i will post it here. Won't be till tomorrow now though cos i need some sleep

Cheers,

Matt

[sub]

The messages in the current release are as follows:

WM_GBPVR_CONTROL = 0x00008003

WPARAM = key
192 = 0
193 = 1
194 = 2
195 = 3
196 = 4
197 = 5
198 = 6
199 = 7
200 = 8
201 = 9
224 = Up
225 = Down
209 = Left
208 = Right
229 = Enter
223 = Escape
205 = Home

242 = Ctrl-R (reverse
244 = Ctrl-F (ffw)
245 = Ctrl-P (play)
240 = Ctrl-Q (pause)
246 = Ctrl-S (Stop)
228 = Ctrl-Left (Skip-)
222 = Ctrl-Right (Skip+)
238 = Ctrl-G (Green)
233 = Ctrl-B (Blue)

[msm]

Thanks for these. I will work on the .gml tonight and get it sent over.

Matt

[msm]

I take it the Lparam in those commands is 0?

Cheers,

Matt

[sub]

Its not used. zero will fine.

[msm]

hmmm, can't get it to work with zero. I can get it replicating key strokes fine, but not using sendmessage.

I will keep at it and see if i can come up with anything,

Matt

[msm]

Right. I now have a working girder set-up but it uses the keystrokes rather than the messages because i could not get GBPVR to recognise any of those messages sent by Girder. I'm not sure if they are not available externally or not? my experience with windows code is limited, but i may try to knock up a few c++ routines when i have a few spare minutes to see if i can get the commands sent form that. Girder is normally very good though so it may be i am just over looking something -normally is .

I have no webspace to host the .gml but if you want it drop me a PM and i will email it over to you. It is very basic at the moment, just supporting those commands above, but i will expand it with channel changing etc etc (hoefully get LCD master integrated at some point ) as and when they become available and i have time to put them in.

Cheers,

Matt

[sub]

msm's GML file for controlling GB-PVR can be found on the new downloads page at http://www.gbpvr.com/downloads.htm

Girder's all greek to me, but I'm sure msm will be able to answer any questions on using it...

[dutchal]

I've been working with girder too, made some LCD plugins to display output on custom lcd displays and I recently worked on software that enables me to send input from a gamepad (try to get 12 input keys that cheap any other way ) to girder. This is rather simple, you only require on DLL. The info can be found on the girder homepage under online help - faq - actions - "How can I trigger a Girder event from outside of Girder"

I have not yet tried to send any strings to girder.