Followed install instructions- No go

[zaldwaik]

That will be a problem since the syntax checker didn't find that MAC in your config.xml file and GBPVR will treat your NMT as an MVP.

However the biggest problem is what I suspected. You have selected 1080p 59.94Hz as your default (which is actually not an ATSC standard) and that is not a mode I currently support. If you want to continue to use that as your default for mkv, mp4, avi and dvd playback that is fine, but you will need to add -m 1080p to your startmeup and run at 60Mhz with GBPVR.

Martin

I can change the default to 1080p 60, will that work?

[mvallevand]

That will work with no command line parameters if that is what you want to use.

Martin

[zaldwaik]

I switched to 1080p 60, same problem

[mvallevand]

Since you mention trying both the Network Browser and through the share you might need to to power off since you cannot switch between them.

If it is still a problem, I updated the syntax check again run it again and post the output.

Martin

[zaldwaik]

Sorry, same problem, here is the output

Checking for mvpmc share on PVR
mvpmc f:\mvpmc

Checking GB-PVR.html links
<a href="http://localhost.drives:8883/NETWORK_SHARE/PVR:mvpmc/gbpvr.cgi">GB-PVR</a>
<a href="http://localhost.drives:8883/NETWORK_SHARE/NETWORK_BROWSER/browser.cgi">GB-PVR via Network Browser</a>
<a href="http://localhost.drives:8883/USB_DRIVE_A-1/mvpmc/usb_a.cgi">GB-PVR via USB</a>

NMT IP Address: 192.168.1.9 MAC 001B2FE0A5A8

GB-PVR Installed c:\Program Files\Devnz\GBPVR\

Checking NMT Version
01-17-091022-15-POP-403-000

Checking NMT Display
1080p 60Hz

Calling NMT Source

[mvallevand]

It's doesn't seem to be finding the config.xml setting yet, but the biggest problem is that the syntax checker is supposed to find a share Source on your NMT. When you go onto the NMT's Source screen do you seen one called called PVR:mvpmc ?

Martin

[zaldwaik]

I have not setup a shared source yet, I was just trying to verify functionality through the html page before going any further. Should I add the source? (I think I should leave the name blank?)

Do you need to see my config.xml?

[mvallevand]

Ok, now I know where you are. Through the network browser you should be able to connect if there is no firewall and mvpmc is a guest share. I will look at your GBPVR logs and config.xml if you send them.

For the source, when I say "leave blank" don't try and name the Source, it will default to PVR:mvpmc if everything is working correctly.

Martin

[zaldwaik]

My firewall is disabled, the share was created by the install and it looks fine. Here are my logs.

[mvallevand]

Yesterday you re-configured GBPVR to not AutoStart an MVP Server

getValue: /settings/MVPServerAutostart : 0

Martin