BlackGold 6in1

[Jase]

Thanks thats sorted it. This is a new machine im setting up with vista on for a htpc in the living room, i must be mad.

Thanks Jase

[chris71]

I've also got one of these cards and I am trying to install GB-PVR for the first time.
But each time I do the 'Map digital channels to EPG channels'. I get a no channels found message.
This is using DVB-T and DVB-S. Both are tuning fine in Vista media center (DVB-T) and DVBviewer(DVB-S).

You can also see TV pics flash up when it is scanning for services, but they do not register for some reason.

Jase, I see you had this problem to begin with, how did you cure it?

[sub]

Did you remember to disable the media center services? Otherwise it'll be handing on to the devices and they wont work in GB-PVR.

[chris71]

Thanks for the reply sub, I hadn't disabled the services, but i think I have now, i've disabled and stopped:

Windows Media Center Extender Service
Windows Media Center Receiver Service
Windows Media Center Scheduler Service
Windows Media Center Service Launcher

Tried a rescan and still get the no channels found after the scan. are there any services i've missed?

[sub]

Do a scan then zip and attach the config.exe.log and config.exe-native.log and I"ll take a look.

[chris71]

Thanks sub,

Just done a scan on all 4 tuners. both logs attached.

Chris.

[sub]

2008-03-12 18:44:15.909 VERBOSE FindFilterByName failed to locate filter: GB-PVR PSI Parser

Run ReRegisterFilters.bat then try again.

If you're on Vista you'll probably need to run this from a command prompt that is running as administrator.

[chris71]

Nice one sub, thats worked a treat, scanning sky as wee speak and the channels are now registering.

Thanks again,
Chris.

[BigB]

I have been following this thread trying to get GBPVR working. I have applied the NativeUtilities patch and disabled Media Centre.

When I run the Re-Register Filter batch file it fails with the message "call to DLLRegisterServer Failed with error code 0x80070005". I have ran batch file as administrator, and from command prompt, and always get the same answer.

Can anyone help please.

Thanks


PS I have now managed to run Re-Register Filters.bat. I did this my running from command prompt, in the folders directory, and opened the command prompt in administrator mode. So, I will now try GBPVR again.

[BigB]

I have managed to get one of the DVB-T TUNERS running but gbpvr reports 'unable to start BDA Device' when i try to map digital channelst to the remaining three.

The picture on the tuner I have running is also rather poor with either cyberlinx or ati mux encoders.

Any suggestions please?

thanks