Failed to lock a signal

[roy]

Can you make sure there is no other recordings pending during this test, then schedule one to start, and a second to start 5 minutes later, so that they overlap but dont start at the same time. Can you then zip and attach the npvr.db3 prior to it starting, then collect the nrecord.log after the start time has passed for both recordings, and post them?

I did two manual recordings, one with 5 minutes pre padding, I hope that works. (I still can't enter manual recording time other than 10 minute increments).

Can't attach it, too big. I'll PM.

[sub]

I did two manual recordings, one with 5 minutes pre padding, I hope that works.

Should be ok. PM me where you download.

I still can't enter manual recording time other than 10 minute increments

You can type 4 digits to have it start at other times. ie 1643 would start at 16:43.

[roy]

Should be ok. PM me where you download.

Done

You can type 4 digits to have it start at other times. ie 1643 would start at 16:43.

That still does not work for me.

[sub]

Are you using a keyboard or a remote?

[sub]

Hmm, those logs looked fine. What happened with those two recordings?

[roy]

They were fine.

[roy]

Are you using a keyboard or a remote?

Ah yes, now I see that it works with the remote, not the keyboard.

[sub]

It works with my keyboard. Did you use the main number keys, or the number pad?

[sub]

They were fine.

Ah, right - that doesnt help then. Can you try again to reproduce it, with a few minutes between recordings starting.

[sub]

Will you want npvr.db3 again?

I dont think so.

It has happened on one off recordings but it's usually reproduceable on back to back recordings. Do you not want to see that?

Ok try back to back, but keep the scenario as simple as possible

BTW - sorry, accidentally overwrote your post, so I deleted it.