Installation of NextPVR on Libreelec

[mvallevand]

It is installed by the script, sub gave you an example, I gave the actual command to use.

Martin

[sub]

I didn't know where the tuning file was on LibreElec, so I thought it was obvious in the example I gave that you had to substitute the actual tuning file path. As Martin kindly offered:

dvbv5-scan -a 1 /storage/.kodi/userdata/addon_data/service.nextpvr/dtv-scan-tables/dvb-/au-Melbourne

[mvallevand]

Oops I forgot a "t" though so it would be

dvbv5-scan -a 1 /storage/.kodi/userdata/addon_data/service.nextpvr/dtv-scan-tables/dvb-t/au-Melbourne

Martin

[jack2296]

just ran the command and got this:

[mvallevand]

I suspect you will have to use the command I gave you to create the full mux.

Martin

[jack2296]

need a little help here as I am not expert. I ran this "dvbv5-zap melbourne ABC -P -t 60 -o fullmux.ts" and got a file not found error.
The last post I ran "dvbv5-scan -a 1 /storage/.kodi/userdata/addon_data/service.nextpvr/dtv-scan-tables/dvb-t/au-Melbourne "

[mvallevand]

Did you create the file melbourne with the content I gave you? If so is it in the folder you are running the command from?

Martin

[jack2296]

yes the file is in this location"/storage/.kodi/userdata/addon_data/service.nextpvr/dtv-scan-tables/dvb-t/au-Melbourne".

[mvallevand]

Here https://forums.nextpvr.com/showthread.ph...#pid569983 I asked you to create a file called melbourne

Martin

[jack2296]

Yes I ran the first command and was ok (see above), Then ran "dvbv5-zap melbourne ABC -P -t 60 -o fullmux.ts" and got the file error ,attached.