Sat-ip Nextpvr only finds 12 channels

[lostboy]

So have you tried your h/w tester on the lnb cable at end that connects to the telestar?

[Qvex23]

So have you tried your h/w tester on the lnb cable at end that connects to the telestar?

I think I did, I will do tonite and test again. Thanks for all the help.
Can someone please tell me, how I need to format a URL for a valid FTA Channel to the SAT-Ip Device, to open Stream in VLC?

Code:

rtsp://172.27.0.11:554/?src=1&freq=11553&sr=22000&pol=h&fec=23&msys=dvbs2&mtype=8psk&pids=0,16,17,18

What would that be for i.e. ZDF? Where can I find that information?

[lostboy]

You might be able to download a list from satip.info

[Qvex23]

You might be able to download a list from satip.info

Is that Port 554 correct? in that satip.info m3u are only links without that port

[mvallevand]

Earlier you wrote "I can telnet to the Sat->IP Device to Port 554." so we assume the port is correct.

Martin

[Qvex23]

Good and Bad News. I was on the wrong Satelite (Astra 4B instead Astra 1H). I changed to Astra 1H an could perfectly watch TV on my Satelite Finder. Even TVHeadend finds 1500 Channels, but NextPVR doesnt find any Channel

[sub]

If you're willing to temporarily setup your router so I can access your port 554 on your SAT>IP device (172.27.0.11), and PM me the IP address:port you've forwarded, I'll try scanning it here, and see what it's unhappy about.

[Qvex23]

If you're willing to temporarily setup your router so I can access your port 554 on your SAT>IP device (172.27.0.11), and PM me the IP address:port you've forwarded, I'll try scanning it here, and see what it's unhappy about.

Done, Port is 1:1

[sub]

Actually I'm not sure I'm going to be able to do it remotely the way I was trying. There is udp stuff that isn't going make it through the firewall.

Restart NextPVR, then on the Settings->About page, hold the Ctrl key. Click the 'enable verbose' button that appears, then try scanning again, and repost the logs.

[Qvex23]

Actually I'm not sure I'm going to be able to do it remotely the way I was trying. There is udp stuff that isn't going make it through the firewall.

Restart NextPVR, then on the Settings->About page, hold the Ctrl key. Click the 'enable verbose' button that appears, then try scanning again, and repost the logs.

Ok. I enabled Verbose. The Portforwarding was for TCP and UDP. Maybe I can let you Tunnel into my network for debugging if you want