Installation of NextPVR on Libreelec

[jack2296]

Is it the "au-Melbourne" full file or the modified "melbourne" file you gave me?

[mvallevand]

I did repost the command I wanted you to run.

Martin

[sub]

success found it and placed it on my one drive link below:
https://1drv.ms/u/s!Aq54CwkIOV7cg2R9cQt5...R?e=xugmf8

Thanks. I've downloaded it, and like Martin, I could see the channels including names in there.

I'll load it up here in my signal generator, and try a scan with a DVB-T stick, and see if I can reproduce the issue.

(there is slight possibility it can be resolved by updating the DeviceHost/x64/libdvbv5.so.0 file included with NextPVR)

[sub]

Annoyingly it's finding the channels when I scan here.

[jack2296]

here is the config file requested

[mvallevand]

It seems like you scanned from my mebourne file but in any case like sub it did work. Could you try from NextPVR again?

Martin

[jack2296]

I cut and pasted the last command you gave me "dvbv5-scan -a 1 /storage/.kodi/userdata/addon_data/service.nextpvr/dtv-scan-tables/dvb-/au-Melbourne, I added the t to dvb- which was missing.
Interestingly I scanned the "melbourne" file and it worked ok however when trying to scan a second time with "au-Melbourne" it just sat there. Equally I found the same issue when trying to import a m3u list.

[mvallevand]

Doing the melbourne only scan would overwrite the full scan so that makes sense now. I am not sure why the full scan impacts ABC. As a work around you can move the melbourne file into dvb-t folder and do a second scan with NextPVR I think sub now will merge scans.

Martin

[jack2296]

Thanks, intergrated "melbourne" into "au-Melbourne" and works well.
I then tried to import a m3u file using "IPTV Device" however nothing happened, it just sat there. Is there a IPTV scanning table I need to install or should it just work?

[sub]

Thanks, intergrated "melbourne" into "au-Melbourne" and works well.

Great! Odd, but glad you've got a work around.

I then tried to import a m3u file using "IPTV Device" however nothing happened, it just sat there. Is there a IPTV scanning table I need to install or should it just work?

You don't really scan IPTV. On the Settings->Devices page, if you click the IPTV device, you'd normally be able to use either 'Import M3U' or 'Import XC' buttons at the top right. You'd typically use IPTV details provided by an IPTV provider.

There are some free services available too. It looks like in Australia you could probably use something like the following with 'import M3U':

M3U url: https://i.mjh.nz/au/Melbourne/raw-tv.m3u8
XMLTV url: https://i.mjh.nz/au/Melbourne/epg.xml.gz