NPVR v504

[mame]

I know, but as I had already said in a previous post, the channels to be modified would be many (not only the ones I am exemplifying) with an excessively expensive editing job.

Anyway here a last today's scan, same problems ...
Today I tried as said. What I did: I performed a complete scan on the TV (everything OK as usual), then I disconnected the TV and connected the tuner to the same connection as the TV.
At this point I would like to understand if I am wrong with the scan mode: from setting I delete the existing channel list and run a new scan.
It's correct?

Attached: today's channel.db3 and report about yesterday and today.

[mame]

The big question, ignoring the LCN issue is are you able to get channels on the frequencies that you want?

Martin

Yes, I get all frequencies scanned, anyway, as you can see in my reports, the LCN differs each time and often some channels are NOT tuned.

[Graham]

Yes, I get all frequencies scanned, anyway, as you can see in my reports, the LCN differs each time and often some channels are NOT tuned.

Did changing scandroptime make a difference?

[mame]

Well, just as a last test, I changed the ScanDropTime to 9000 but the results are even worse!

[Graham]

Well, just as a last test, I changed the ScanDropTime to 9000 but the results are even worse!

Do a scan with 9000 and then attach the logs. Thanks.

[sub]

The ScanDropTime setting is ignored in v5. It doesn't do anything.

I will likely need to add support for this in v5 to work around your issue.

[mame]

The  ScanDropTime setting is ignored in v5. It doesn't do anything.

I will likely need to add support for this in v5 to work around your issue.

Well, I'll wait for that, let me know.
In the meantime do you need any logs?

[sub]

Post another set of logs covering a scan and I'll take a look.

[mame]

Post another set of logs covering a scan and I'll take a look.

Here it is (it contains also the npvr.db3 and my REPORT).
Thanks.

[sub]

Your logs confirm it's exactly what was mentioned earlier. Due to timing issue, sometimes it doesn't receive the LCN number of the channel, so the channel just gets allocated the next channel number.