New Features

[Azimuth]

Two of us mentioned it actually & I can't even see anything in the list views when I do change to them & coversview don't scroll properly, in fact it is almost not usable.....so actually on the NMT with this build NPVR is almost totally unusable for me.

I have this problem, and discovered that if I go into a sub folder and then change it, when I click on "back", it will refresh correctly from then on.
I looked in config.xml to see if there was a way to default to list view, it looks like there isn't.

[JimmyA]

I am able to use this card successfully in GBPVR using graphrecorder. I have installed NVPR and would like to set this up as an analog device, filtercheck logs attached.

However, NVPR only sees it as an ATSC device. Is there anything that I can do to make it recognize it as an analog device?

Thanks

[sub]

I am able to use this card successfully in GBPVR using graphrecorder. I have installed NVPR and would like to set this up as an analog device, filtercheck logs attached.

However, NVPR only sees it as an ATSC device. Is there anything that I can do to make it recognize it as an analog device?

Thanks

I have no idea if that device will work for analog or not it. It might, but you'd need to get the Hauppauge SoftPVR components from someone, and register the *.ax files, then add the following to your AnalogDevices.ini file:

Code:

    <Device filter="AVerMedia 716x BDA Analog Capture">
        <Name>AVerMedia 716x</Name>
        <Type>SOFT_ENCODE</Type>
    </Device>

[JimmyA]

Sub,

Thanks for the quick response. Any idea where I might get the Hauppage SoftPVR components?

[Jaggy]

I have this problem, and discovered that if I go into a sub folder and then change it, when I click on "back", it will refresh correctly from then on.
I looked in config.xml to see if there was a way to default to list view, it looks like there isn't.

Well done Azimuth by following your instructions I can again use my NMT (up to a point) with NPVR & I do like the new interface & can't wait until sub sorts all the NMT issues out.

[IanSav]

Hi Sub,

I've put small left/right arrows next to the active list to give a visual indication there is something left/right. The user can also click them.

In the past I had tried the dimmed scrolling list like you described, but it didnt look quite right.

Your solution is simple and solves the problem. Thank you.

Regards,
Ian.

[JimmyA]

Just another quick question, I only know enough to be dangerous. If I am using a TWC digital cable box, why would I get no channels when I scan?

Thanks Again

[sub]

Just another quick question, I only know enough to be dangerous. If I am using a TWC digital cable box, why would I get no channels when I scan?

Are you trying to scan for digital channels? Your cable box output one analog channel, ie the current tuned channel, so a digital scan wont find any channels.

[JimmyA]

Forgive my ignorance, is there something else I need to do? I just hit Scan on device setup.

[sub]

Forgive my ignorance, is there something else I need to do? I just hit Scan on device setup.

As mentioned earlier, if you dont have the SoftPVR components on your machine, analog support is disabled. Since you're using a set top box, you're getting an analog feed to your machine.

I'm guessing you dont see the Analog 'AVerMedia 716x BDA Analog Capture' device listed on the Devices screen?